Quick Answer: How Long Does Thompson Water Seal Last?

What happens if you stain over stain?

1.

Staining over stain is easy and works beautifully if your applying a dark stain over a lighter stain on raw wood.

2.

You can mix 2 or more stains together to make DIY custom stains..

Why is my wood stain not drying?

If you applied the stain correctly, and it still remained tacky, it could be due to rainy weather or high humidity. … In either case if the tackiness doesn’t go away, wipe the wood down with mineral spirits or naphtha to remove most of the stain, let it dry thoroughly, then try again using a fresh can of stain.

How do you know if wood stain is bad?

There are some ways to tell if it’s time to finally let your wood stain go and toss it out, rather than preserving it. First, start with a visual inspection. If you open up your can of wood stain and its contents look separated, stringy, rubbery, or thick, it may be time to throw it out.

Is Thompson Water Seal any good?

5.0 out of 5 stars Love Thompson’s Water Seal with the harvest gold color! Basically, it takes your weather worn fence and restores it back to almost new looking boards, plus protecting it from the elements. I used my spray gun to apply, and a little goes a long way. Obviously, you can use a brush to apply it as well.

Is it better to stain or seal a deck?

A: It’s really up to you. Just staining the deck will give you the color you want, although in high-traffic areas the stain could wear away quickly. … The advantage of this, they say, is the sealer provides additional protection against water and weather damage, while the stain helps reduce fading from UV rays.

Should I use Thompson Water Seal on pressure treated wood?

However, most pressure-treated wood should have periodic sealing against moisture, preferably every year or so. … The directions for some, such as Thompson’s Water Seal, specify pressure-treated wood as a suitable use.

How much area does a gallon of Thompson’s Water Seal cover?

400 square feetThat determines how many gallons of stain are required (each gallon covers up to 400 square feet).

How many coats of Thompson Water Seal do I need?

2 coatsshake the can vigorously before use. Thompson’s Water seal has a slightly milky appearence in the can,but clears quickly upon application. For best results ensure the surface is as dry as possible. Apply 2 coats using brush,roller or sprayer.

Is Thompson’s Water Seal oil based?

Thompson’s® WaterSeal® Penetrating Timber Oil is an oil-based product that provides protection by penetrating into wood pores and sealing out water infiltration. Thompson’s® WaterSeal® Waterproofing Stains are water-based products that have film-forming properties to protect the wood by repelling water.

Can you throw away empty stain cans?

How do I dispose of empty paint cans? If the cans from your oil-based paint or stain products are empty, put them into your regular trash.

How often do you have to apply Thompson’s Water Seal?

every one to three yearsApplying a sealer and/or stain typically is recommended every one to three years, depending on the finishing product, deck use, weather conditions, and sun exposure. All Thompson’s WaterSeal products are DIY-friendly, and most need only a single application on a clean, dry deck.

How do I dispose of Thompson Water Seal?

Wrap container and put in trash. Do not contaminate water, fooc., or feed by storage and disposal.

What happens if it rains after applying Thompson’s Water Seal?

Moreover, what happens if it rains after applying Thompson’s Water Seal? Rain will damage the finish of any wet sealer with linseed oil or mineral oil in it. Because it forms a coating, it takes several hours to “set up” (dry) and during that time the sealer is vulnerable.

Does Thompson Water Seal go bad?

Acrylic- and latex-based sealer are both water-based. Similar to paint in its consistency and shelf life, if stored in a cool, dry place, it should last approximately five years.

How do you dispose of wood sealer?

Wood preservatives that contain creosote or pentachlorophenol or wood preservatives that cannot be used up, should be safely stored until you can dispose of them at the household chemical cleanout collection, which is held in the Eurobodalla on an annual basis.

What is the best way to apply Thompson’s Water sealer?

Steps to TakePour the sealer into a deck.Dip the paint pad into the seal.Bring the seal onto the tray area.Start at one corner and work from one end to another.Apply the sealer parallel to the deck boards.Now allow the deck to thoroughly dry. Thompson water seal dry time takes about 24 hours to dry thoroughly.

What happens if you don’t wipe off excess stain?

Wood stain is designed to penetrate into the grain of the wood, not to remain on the surface. If you happen to spread it too thickly, or you forget to wipe off excess, the material that remains on the surface will become sticky.