Quick Answer: Can You Use Water Based Paint Over Zinsser BIN Primer?

When can I paint after priming?

Primer Drying Time Most latex primers dry to the touch within 30 minutes to 1 hour.

But do not paint the wall until the primer dries thoroughly, which can take up to 3 hours.

High humidity and cool temperatures prolongs drying times..

Can you use latex paint over Zinsser oil based primer?

Sanding helps the primer stick better, and you’ll have a smoother finish if you sand between each coat. … Latex paint over Cover Stain oil primer is perfectly fine. Question: Will the Zinsser Cover Stain primer work on top of preexisting water-based painted cabinets?

Why can’t you use TSP with Zinsser primer?

In doing an house where there had been heavy, heavy smoking (the nicotine was running off the walls) I emailed the Zinsser site asking why they do not recommend washing the walls with TSP first. Their reply was that the TSP could leave a residue that made the primer less effective.

How many coats of Zinsser primer should I use?

Very porous surfaces may require two coats which may reduce the square foot coverage of the product. B-I-N is an excellent interior stain killing primer. One coat effectively blocks stains, including water, nicotine, ink, crayon, marker, rust and smoke stains so they will not bleed into the topcoat.

Can you use water based paint over shellac?

Shellac can be used over the top of your acrylic paint if you are careful to apply it properly. You can use one coat to seal the wood. All you need to do is rub it on liberally and then wipe the surface to seal it.

Is shellac water based or oil based?

While oil-based poly requires 4 hours to dry between coats, these finishes are much faster: Lacquer (30 min.) Shellac (1 hr.) Water-based poly (2 hours)

Is oil based primer better than water based?

Slower-drying oil-based primers, such as an enamel undercoat primer, provide better adhesion and are easier to sand than water-based primers. If you use a water-based primer, it’s likely to raise the grain of the wood and require more sanding before you apply the topcoat.

Can you use water based paint over Zinsser BIN?

Zinsser’s primers (BIN, 123 and Cover Stain) all say in their technical docs that they can be painted over with any water-based or solvent-based topcoat.

How long does Zinsser primer need to dry before painting?

Dry Time– In most cases B-I-N® will dry to the touch in 20 minutes and can be recoated in 45 minutes. The dry primer film develops full adhesion after it cures in 1 to 3 days. Lower temperatures, higher humidity and the addition of tint will prolong dry and cure time.

Can water based paint go over shellac primer?

Can I used latex paint over shellac or oil based primer? Or oil based paint on latex or shellac primer? Yes, you can use ALL 3 types of primers over or under latex and oil based paint. Some glossy surfaces will benefit from sanding first.

What’s the difference between Zinsser BIN and Zinsser 123?

BIN is solvent (methylated spirit) based, 123 is water based both are good stain blockers but BIN is better for resin (knots etc) only for spot priming when used outside (no idea why I painted a whole stack pipe in it no problem) while 123 is for large areas. 123 seems better on plaster surfaces in my view.

What is the best primer to use when painting kitchen cabinets?

According to the Dowdings, the best primer is INSL-X Prime Lock. “This resin-based primer is a sealer as well, so nothing bleeds through. Plus, it’s easy to handle, and it’s a good bonding primer for paint to go onto,” says Chris.

How long can I wait to paint after priming?

In most cases, latex primers don’t take more than an hour to dry out. However, you should wait three to four hours before applying a layer of paint. On the other hand, an oil-based primer will need a longer time to dry out. You should give it 24 hours to make sure that it’s completely ready for another coat.

What kind of paint do you use on shellac primer?

Shellac Primer They work well on wood, metal, plaster, and even plastic, and are fast drying and highly adhesive. They also can be used with both oil-based and latex paints.

Can I use latex paint over shellac based primer?

B-I-N, developed in 1946, is the original shellac-based white-pigmented primer-sealer stain-killer. Great for use on all interior surfaces & spot priming on exterior surfaces. It is formulated to seal, prime and block out stains on previously painted or new work. Any oil or latex paint can be applied over it.